Screen printing is widely used to apply photoresist in copper-plated silicon heterojunction (HJT) solar cells, but the process can damage the cells’ sensitive passivating contacts and reduce conversion efficiency. The mechanical pressure and thermal treatments involved can increase recombination losses. A research team in China has investigated the degradation mechanism and proposed a modified screen design intended to limit that damage during commercial production.
The problem differs from conventional silver-paste printing, corresponding author Lang Zhou said. Silver paste screens have openings covering only 2–5% of the area, with an emulsion layer protecting the wafer from direct mesh contact. Full-area photoresist coating typically uses a screen without emulsion coverage, so the mesh touches the wafer extensively during every printing cycle.
Earlier production data showed efficiency falling from 26.2% to 25.7% over 15,000 consecutive printing cycles. Open-circuit voltage and fill factor accounted for most of the loss, while short-circuit current density and electrical resistance remained largely unchanged. Minority-carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Using three-dimensional confocal microscopy, the researchers traced the decline to progressive wear of the screen-mesh knuckles. As these knuckles flattened, their contact area with the wafer increased, raising mechanical stress on the passivation layers beneath. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements indicated higher recombination losses, pointing to damage at the amorphous-silicon/crystalline-silicon interface.
To reduce that contact, the team developed an emulsion buffer layer on the screen and evaluated six patterns with emulsion coverage ratios from 2.9% to 16.6%. Higher coverage provided more mechanical protection but interfered with photoresist distribution, creating a trade-off between protecting the wafer and maintaining uniform coating.
A coverage ratio of 4.7% gave the best balance. After 10,000 printing cycles, minority-carrier lifetime degradation was limited to 0.41%, while coating uniformity remained relatively good. The researchers attributed the improvement to the emulsion layer preventing direct contact between the mesh and the wafer, reducing cumulative mechanical damage to the passivating layers.
“The findings demonstrate that a relatively simple modification to screen design can substantially mitigate printing-induced degradation, offering a practical approach to improving the manufacturing reliability of copper-plated HJT solar cells,” Zhou said. The results were published in Solar Energy.
The work comes as copper metallization attracts interest as a way to reduce silver use in HJT cells. In April 2026, researchers at China’s Nankai University reported a silver-free HJT cell with 25.2% efficiency, using plasma-induced interface engineering and copper electroplating to address adhesion, contact resistance and stability at the ITO interface. Separately, Germany’s Forschungszentrum Jülich achieved 23.08% efficiency in a fully copper-metallized HJT cell, a relatively small penalty compared with its silver-metallized counterpart. Cells combining silver-copper paste on the front with silver contacts on the rear reached 23.95%. Those results underline copper’s potential to cut silver consumption, while further improvements in processing and electrical performance are still needed.
