Instruments & Meters

Instron highlights high strain rate testing for more representative simulation

Petra DahlbergOctober 25, 20265 min read3 views

At a glance

  • The testing specialist says dynamic material data can narrow simulation gaps and inform material selection, but test conditions still shape what can be captured.
  • Instron application engineer Andrea Incardona explains how high strain rate testing can provide data for crash simulation, material selection and product development, citing a 2025 CFRP study that reduced simulation discrepancies. The approach depends on material, specimen and test method, with tests often lasting only milliseconds.
A composite specimen sits between metal test bars in a high strain rate testing setup, with a high-speed camera and a translucent crash-structure model nearby.

Instron application engineer and product specialist Andrea Incardona has outlined how high strain rate testing can supply more representative material data for simulation, material selection and product development, arguing that the relevance of test data matters as much as its volume.

Many materials are strain-rate dependent: their mechanical response changes as loading speed rises. A material characterised under quasi-static conditions may therefore behave differently in a rapid impact or crash. Instron says this gap can limit the value of models built only on conventional properties.

Crash simulation study

Incardona cites a 2025 study in the SAE International Journal of Materials and Manufacturing, “Influence of Strain Rate Effect on Mechanical and Crashworthiness Properties of CFRP Composite Structures.” According to the article, incorporating strain-rate-dependent material properties into crash simulations reduced the difference between simulated and experimental results. Peak acceleration discrepancy fell by 6.5 per cent, while mean acceleration and displacement discrepancies fell by 5.9 per cent and 6.3 per cent respectively.

The implication is not that every model needs every possible strain rate, but that data should reflect the conditions a component is expected to face. If strength, stiffness, deformation mechanisms or failure behaviour change as strain rate increases, conventional data alone may leave a model unable to represent a rapid event accurately.

Test conditions and data capture

Instron says high strain rate characterisation can cover quasi-static conditions up to strain rates approaching 1,000/s, depending on the material, specimen geometry and test method. Tests can last only 3 to 10 milliseconds, so data acquisition must resolve rapid changes in force and deformation. Instron’s systems support acquisition at up to 200 kHz; digital image correlation can add information on strain development across the specimen, and analysis tools can support processing and theoretical modelling.

The company presents these capabilities as part of a broader development workflow rather than a final check on an existing design. Dynamic data can be used earlier to compare candidate materials, refine component designs and assess how changes might affect performance before physical validation.

Material selection and weight trade-offs

Conventional strength and stiffness values are important, but they may not distinguish materials that behave differently under rapid loading. Two materials that look comparable in standard tests could deform, absorb energy or fail in different ways at high strain rates. That makes dynamic characterisation relevant where performance must be balanced against weight, such as automotive crash structures or aerospace components.

The article’s central claim is that better material data can make simulation more representative and help engineers make better decisions from material selection through product development. The boundaries are practical: the applicable strain rate, specimen design and test method determine what can be characterised, and the data must still be validated through physical testing.

Reported by Petra Dahlberg, Thermal and Fluid Equipment Specialist.