SinceVision has introduced the SGI-N030W, a wide-spot laser displacement sensor designed for high-speed, non-contact dimensional measurement on rough, textured and irregular surfaces. The company says the sensor extends its SGI Series and targets lithium-ion battery manufacturing, semiconductor processing and precision mechanical engineering, where micrometre-level measurement is required.
The product is intended to address a common limitation of conventional point-spot laser displacement sensors. Those systems concentrate reflected laser energy on a small area, so microscopic scratches, grain boundaries, brushed textures and matte finishes can produce signal variations that are read as dimensional changes. Such false readings can trigger defect warnings and additional inspection, according to SinceVision.
Expanded spot averages surface features
The SGI-N030W uses an expanded laser spot and optical triangulation. By collecting reflected light across a broader surface area, it averages localised microscopic peaks and valleys before signal conversion, reducing the influence of surface roughness and optical scattering. SinceVision cites drawn metals, sandblasted surfaces and coated battery foils as materials that can benefit from the approach.
Specified measurement performance
The sensor has a 30 mm reference distance and a ±5 mm measurement range. SinceVision specifies repeatability of 0.05 µm on a diffuse white target under static conditions and linearity of ±0.02% of full scale. A 50 kHz sampling frequency, equivalent to a 20 µs update interval, is intended to support high-speed measurement and monitoring of dynamic processes. Communication options include RS485, 100Base-TX Ethernet and switchable analogue outputs for 4–20 mA current or 0–10 V voltage signals. Master-slave synchronisation allows two sensors to operate in opposition for simultaneous measurement from either side of a component or moving material.
Battery electrode thickness measurement
One principal application is in-line thickness measurement of lithium-ion battery electrodes. Coating thickness and uniformity affect energy density, internal resistance and long-term cell stability. SinceVision notes that offline inspection with contact micrometers or drop indicators can introduce operator variability and may deform wet or uncured electrode material. Periodic spot checks also cannot provide continuous coverage across a production reel.
In the proposed arrangement, two synchronised sensors sit above and below a moving electrode web on a calibrated, low-thermal-expansion marble gantry. The opposing heads measure their respective clearances to the material, and a controller combines these readings with the fixed mounting datum to calculate absolute thickness in real time. SinceVision says production trials demonstrated stable, repeatable measurement within ±0.3 µm at a web speed of 300 mm/s. The 50 kHz sampling rate is intended to provide high longitudinal resolution, allowing detection of localised coating agglomerations, edge thinning and exposed substrate before the electrode proceeds to cell winding.
Semiconductor and precision-assembly applications
For semiconductor manufacturing, the non-contact design is intended for sensitive wafer surfaces. Potential uses include wafer position verification, edge detection, height measurement and checks of wafer seating and chuck alignment in atmospheric transfer modules and vacuum load-lock systems. In precision assembly, the sensor can monitor voice coil motors, linear actuators and micro-steppers. Its sampling rate is intended to capture transient displacement, mechanical oscillations, settling behaviour and end-stop overshoot across the full range. Position data can be sent to machine control systems through the Ethernet interface for real-time monitoring and process control.
Addressing false defect warnings
Jack Li, global sales and marketing director at SinceVision, says false defect warnings caused by surface texture remain a recurring challenge in battery manufacturing and precision assembly. He explains that conventional point-beam laser sensors can interpret microscopic scratches and rough coatings as actual thickness variations, slowing production lines and creating a need for manual inspection. The SGI-N030W’s expanded optical spot is designed to average out these surface-related variations, while synchronisation between opposing heads supports high-speed thickness verification.
