Tremec has built a working manual-transmission Chevrolet Corvette C8 development car, and a track drive shows both the appeal and the engineering and cost barriers of adding a third pedal to the mid-engine sports car. The car is a one-off Peitz Performance C8 race build, not a production offering from Chevrolet.
Tremec invited the reviewer and several potential customers to sample its transmissions at Motorsports Gateway, a new private track outside Howell, Michigan. The test car used Tremec’s new manual gearbox in place of the C8’s standard dual-clutch automatic. It was a track build with a full cage and harness and essentially no interior finish; the shifter emerged from the area normally occupied by the storage cubby and automatic gear selector.
Installation and driving feel
Peitz Performance did not need major changes to fit the gearbox. The tunnel was cut to install clutch-pedal hardware, but the manual transaxle sits where the stock dual-clutch unit would, without special mating hardware. The C8’s pedal box has room for a clutch pedal and felt roomier than a previous-generation Camaro’s, according to the reviewer.
The shifter is remotely mounted, with a cable running rearward to the transaxle. That layout makes it less precise and less “snick-snick” than the front-engine TR-6060 six-speed used in other GM performance cars, and less notchy. The trade-off may smooth some of the Tremec unit’s rougher edges, but it also loses some of the more mechanical feel of the front-engine installation.
The test car’s seating position had virtually no adjustment and was set for a taller driver. The reviewer, who is 5-foot-7, found heel-and-toe downshifts awkward and could not brace against the floor in corners, limiting how hard the car could be pushed. The session took place on a green track on a November afternoon in Michigan.
Cost remains the main obstacle
The gearbox alone costs about $75,000, according to the article. Combined with the cost of a Corvette, building a manual C8 would rival the price of a showroom-spec Z06. Tremec says the price will fall as volume rises. The company says OEMs are interested, not necessarily or exclusively General Motors; other automakers want a high-torque manual transaxle, though no customers were named.
The drive demonstrates that a manual C8 can be engineered without wholesale changes to the car. It does not establish that Chevrolet will offer one. The remaining questions are cost, volume and whether enough buyers would accept the remote-shifter feel in exchange for a third pedal.
