Industrial Machinery

WITT to Showcase MEM+ Gas Mixers and Safety Valves at FABTECH 2026

Priya RamanOctober 25, 20265 min read2 views

At a glance

  • Booth S46114 will host discussions on gas mixing, pressure regulation and backflow protection equipment for industrial systems.
  • WITT Gas Controls plans to exhibit precision gas mixing and safety products at FABTECH 2026 in Las Vegas, including MEM+ mixers that adjust two- or three-gas blends in less than three seconds. The company will also highlight dome pressure regulators and ULTRA/ULTRAVENT valves for stable pressure and system protection.
A concept image of a stainless-steel gas mixing cabinet with regulators and safety valves, illustrating the equipment WITT plans to discuss at FABTECH 2026.

WITT Gas Controls will exhibit at FABTECH 2026, scheduled for October 21–23 at the Las Vegas Convention Center, and will use Booth S46114 to discuss precision gas mixing, pressure regulation and safety equipment.

The company, which describes itself as a global provider of gas safety, control and analysis solutions, plans to feature its MEM+ gas mixer series alongside dome pressure regulators and gas safety valves. The highlighted products address three tasks: achieving a specified gas mixture, holding pressure steady and protecting equipment from backflow or overpressure.

Mixer control and accuracy

According to WITT, the MEM+ series mixes two or three non-flammable gases, including nitrogen, carbon dioxide and oxygen, for a range of industrial applications. Electronically operated, motorized proportional valves allow adjustments in 0.1 percent increments. The system can reach the desired mixture in less than three seconds with accuracy better than ±1% absolute, the company says.

The mixers offer seven interface options, including Ethernet, OPC UA and PROFINET, for integration with existing systems. Operators can control them remotely through a PC, PLC or machine controller, or directly through a touchscreen interface. Pressure equalization compensates for supply pressure fluctuations, while continuous inlet pressure monitoring and pressure alarms are included for safe operation. An integrated buffer tank accommodates fluctuating flow rates.

The MEM+ units are housed in a splash-proof, brushed stainless steel enclosure. They support maximum inlet pressures of 20 bar and maximum outlet pressures of 10 bar.

Pressure regulation and valve protection

WITT will also highlight dome pressure regulators that use optimized pilot pressure regulators to maintain stable working pressure as flow rates and inlet pressures change. The company says the design is intended to support consistent process performance and product quality. The improvements can be retrofitted to existing WITT dome pressure regulators without replacing the complete system, according to the company.

In addition, the company will present ULTRA non-return valves and ULTRAVENT safety relief valves. ULTRA non-return valves are described as combining low opening pressures, tight sealing and minimal flow resistance to protect gas systems against unwanted backflow. ULTRAVENT safety relief valves are designed to protect against excessive pressure and respond to pressure increases as low as 5 mbar.

The FABTECH appearance is focused on equipment discussions at the booth rather than announced installations or customer results. WITT's stated specifications cover mixing speed, accuracy, interface options, pressure ratings and valve response thresholds; the company's characterizations of performance and product quality remain its own claims.

Reported by Priya Raman, Crane and Lifting Specialist.