Portal axles are prized in hardcore off-roading because they raise a vehicle’s drivetrain without forcing the axle shafts to hang low. Zeph Gage’s latest project applies that idea to the rear of an XJ Jeep, but with a twist: instead of buying a complete set, he built a low-cost rear-only conversion from mixed parts.
On a conventional vehicle, the axle and differential housing sit below the frame and limit ground clearance. A portal axle moves a set of gears behind each driven wheel, so the axle shafts can sit higher and less hardware hangs beneath the vehicle. Tall tires can then add further clearance. A typical portal-axle set from companies such as 74Weld costs about $20,000, while Gage’s setup costs roughly one-fifth of that, or about $4,000.
Gage’s parts list includes a Ford 9-inch axle housing, Humvee geared hubs and a set of Jesse Haines Fabrication HMMWV portal adapters. The Humvee-style two-gear portals reverse the rotation of the input shaft. To make that work with the Ford 9-inch, Gage flipped the differential upside down so the driveline turns in the correct direction. A Yukon Gear and Axle third member is then bolted to the differential, effectively turning low-pinion parts into a budget high-pinion arrangement.
The conversion is intended to add about six inches of clearance. It also retains full shock travel, a difficult goal with portal axles, and reduces stress on the differential itself. The result is described as effectively bulletproof, though that is a design claim rather than an independently tested outcome.
Installing a portal axle only at the rear may look unusual, but the article notes that it is a common trick in remote-control rock-crawler builds. Keeping the front solid axle avoids the packaging constraints that can arise when portal axles are added to a vehicle that never had them. It also means Gage does not have to limit shock travel because of those constraints, and the ride height does not rise to an extreme level. The approach is presented as a best-of-both-worlds compromise.
This is not an off-the-shelf solution. Gage fabricated homemade brackets and custom-tapped plates, and he used a two-piece brake rotor paired with a Ford Fusion caliper. The Fusion hardware was chosen partly because it offers an integrated electric emergency-brake solenoid, and partly for clearance.
The finished XJ can drive over a five-gallon bucket and still have several inches of spare clearance, according to the article. That means the rear end is less likely to get hung up on obstacles that the front end can steer around. Gage also matched the gearing front and rear, a detail covered in the Outdoor Auto video referenced by the article.
